Custom 75mm 46" EX complete motor. I had this made for my own project, but plans changed and I no longer need it. Motor will accommodate 41.0" of propellant. Depending on your formula, this motor should yield up to about 9K Ns total impulse. All parts are brand new, and everything listed below is included.
Asking $500 plus actual shipping.
(1) 75mm x 46.0" 6061-T6511 motor case with two internal grooves and one external groove
(1) Loki nozzle with 1.0" throat
(1) Loki stainless nozzle washer
(1) custom smoke bulkhead. Smoke well is 1.125" ID x 2.0" deep. Closure is threaded for 3/8-16 eyebolt which has been glued in with JB Weld.
(2) internal snap rings
(1) external spiral thrust ring
(1) pre-cut spiral phenolic liner
(1) 41" casting tube
(4) buna o-rings
Asking $500 plus actual shipping.
(1) 75mm x 46.0" 6061-T6511 motor case with two internal grooves and one external groove
(1) Loki nozzle with 1.0" throat
(1) Loki stainless nozzle washer
(1) custom smoke bulkhead. Smoke well is 1.125" ID x 2.0" deep. Closure is threaded for 3/8-16 eyebolt which has been glued in with JB Weld.
(2) internal snap rings
(1) external spiral thrust ring
(1) pre-cut spiral phenolic liner
(1) 41" casting tube
(4) buna o-rings
Attachments
Last edited: