This thread is to document my L3 project: The AGM Special
Over the years, I accumulated parts for future projects, most of the time acquired at the Ottawa Rocketry Group annual AGM. I currently have the following new parts:
I am planning to certify next June at LDRS in Potter NY. I would like to thanks my TAP: Debra Koloms and Harry (Mickey) Rowe.
I ordered ProLine 4500 epoxy and a 3" x 24" fiberglass motor mount at Composite Warehouse on October 27th.
This weekend I purchased some 9mm baltic birch plywood for the centring rings, e-bay bulk plates and fins.
After cleaning the garage, I washed the fibreglass parts I currently have. Then I cut the bulk plates for the E-bay and the nose cone. I will try to cut the centring rings, the fins and slot the body tube next weekend.
Over the years, I accumulated parts for future projects, most of the time acquired at the Ottawa Rocketry Group annual AGM. I currently have the following new parts:
- 6” 5 to 1 gel coated fibreglass nose cone (Performance Rocketry)
- 6” x 36” G10 body tube (Performance Rocketry)
- 6” x 48” G10 body tube (Performance Rocketry)
- 6” G10 coupler (Performance Rocketry)
- RRC2+ altimeter (Missile Works)
- 2 x Screw switch (Missile Works)
I am planning to certify next June at LDRS in Potter NY. I would like to thanks my TAP: Debra Koloms and Harry (Mickey) Rowe.
I ordered ProLine 4500 epoxy and a 3" x 24" fiberglass motor mount at Composite Warehouse on October 27th.
This weekend I purchased some 9mm baltic birch plywood for the centring rings, e-bay bulk plates and fins.
After cleaning the garage, I washed the fibreglass parts I currently have. Then I cut the bulk plates for the E-bay and the nose cone. I will try to cut the centring rings, the fins and slot the body tube next weekend.