Good morning,
I’m in the early stages of building a Goblin with my kids (our first high power rocket). I’ve attached a few photos and wanted to double check that we’re doing things correctly before applying epoxy. There’s not much of the aft end of the motor tube protruding, and the hardware at that end is the limiting factor. Does this look correct?
We’re planning to go for our level 1 certification with this rocket. What would be a good motor (single use) for this endeavor? I’m not sure if the dimensions of the launch site (white's Fam in Durham, CT) but it’s not prohibitively small.
Thanks in advance for any advice!
I’m in the early stages of building a Goblin with my kids (our first high power rocket). I’ve attached a few photos and wanted to double check that we’re doing things correctly before applying epoxy. There’s not much of the aft end of the motor tube protruding, and the hardware at that end is the limiting factor. Does this look correct?
We’re planning to go for our level 1 certification with this rocket. What would be a good motor (single use) for this endeavor? I’m not sure if the dimensions of the launch site (white's Fam in Durham, CT) but it’s not prohibitively small.
Thanks in advance for any advice!
Attachments
Last edited: