I ended up purchasing the new Ender 5 S1 as my next printer. So far all I have done is put it together, do an initial bed level with a bubble level, run the auto level mesh and then print the small rabbit. After starting the print, I adjusted the Z-compensation and this is what it has done right out of the box with the default Creality PLA that is usually trash. So far I am impressed. I will eventually do a full review on it, but I need to get it into it's final position next to the Ender 5+ so that I can connect it to my RaspPi that I just updated to run Klipper. The print completed in 24 minutes. No sure of the default speed setting that it was sliced with, but I will compare it with another test once I get it tweaked.