The following are the STLs for the prints used in my 2.64" Madcow Bomarc build (
Link)
Reference Photos (Click to enlarge)
View attachment 607689
View attachment 607690
Dorsal Conduit/Tunnel
Top (Green Parts)
Bottom (White Parts)
Wing Hold-Down Anchors (Yellow Parts in airframe)
Fwd Anchor (Left of coupler)
Aft (Right of coupler)
Parts positioned to the left of airframe
Yellow Parts (Left to Right)
Recovery Anchor (Eyebolt mount)
Ramjet Pylon Airfoil/Contour [4 Required]
Red Parts - Front Row (Left to Right)
Ramjet Alignment Jig (Not yet tested)
Tail Section Alignment Guide
Pylon Alignment Guide
Dorsal Marking Guide [v3]