kramer714
Well-Known Member
- Joined
- Jan 20, 2009
- Messages
- 1,190
- Reaction score
- 656
I had a few older altimeters thathad been in 'archived rockets' and decided to clean up an existing av bay design to put them in new rockets.
Simple av bay;
Simple av bay;
- (2) 3d printed parts
- able to use either 2S lipo or 9 volt battery
- only uses one heat set insert (could be threaded directly)
- lots of places for wire management (screws to attach twist ties etc)
- Simple 3d design - easy to print / minimal cleanup (using my old cheep printer)
- Grommet / worm bulkhead mounts
- Shown with e perfectflite minialt but easy to use with RRC2, stratologger CF, strattologer SL100 (I have the hole patters for most of these
- gap for shear pins (can drill them out without worrying about hitting anything...
- snap in place battery holder (can use different holders depending on battery used